Products > Kit & Tools >
Tail Gate Kit
The Tail Gate has become an essential piece of safety equipment since it was first introduced in the mid 1990's. Today, every BASE manufacturer uses the Tail Gate to help prevent line-over malfunctions. The Tail Gate was first used on no slider (slider down) jumps to prevent the, then, very common tail inversion (partial line over) and the dreaded full blown line-over. The Tail Gate is widely used on no-slider jumps and is gaining popularity on slider-up jumps.
- 2 Tail Gates (anti-line over device)
- 6 Small pre-cut rubber-bands for the tail gate
- 4 Medium pre-cut rubber-bands for the tail pocket
image
Image
- Item #61605
- Weight: 113 g
- In stock / $10.00
Customers who bought this also bought:
1/4 lb. Bag Standard Rubber Bands
A quarter pound bag of standard rubber bands made of the highest quality of new gum rubber.
These maximum strength rubber bands are used for the grommeted flap of your parachute's deployment bag.
Made in the USA.
PD Soft Links (Slinks)
Slinks, made by Performance Design, are used to fasten your risers to your suspension lines
and are unmatched in quality, durability, and design.
Each pack contains a set of 4 Slinks with installation instructions.
